4” x 4” x 1/2” Roundo R-4-S Angle Bending Roll

Mobile control console

(1) Set of tooling

Manufactured for Roundo to Model R-4-S specifications.

Machine comes with 1 year parts warranty

Diameter of standard rolls — 12.2”

Angles, leg out — 4" x 4" x 1/2" - 45" dia.

Angles, leg in — 4" x 4" x 3/8" - 48" dia.

Tees, leg out — WT 4 to 40" dia.

Tees, leg in — WT 4 to 60" dia.

Tees, on edge — WT 4 to 40" dia.

Flats, on edge — 5" x 5/8" to 30" dia.

Flats, on flat — 7" x 1-1/2" to 25" dia.

Squares — 2-1/2" to 25" dia.

Rounds — 3" to 25" dia.

Round pipe — 4 Sch 40 to 45" dia.

Square tube — 3-1/2” x 1/4”

Channels, leg out — C7 x 14.75 to 30" dia.

Channels, leg in — C7 x 14.75 to 30" dia.

Channels, on edge — C5 x 6.7 to 200" dia.

Shaft diameter — 4.125”

Motor — 17.4 HP (13 KW)

Volts — 230/460

Cycles — 60 Hz

Amps — 46/23

Approximate dimensions — 67" x 60" x 69" high

Approximate weight — 5,000 lbs

This angle roll was produced for Roundo and manufactured to R-4-S specifications. Roundo did not take delivery of this machine due to the termination of Roundo operations. It is in new condition and has not been put into service. The Roundo R-4-S has a capacity of 4” x 4” x 1/2” angle and comes equipped with a mobile control and one set of tooling.

For questions or to schedule an inspection of this Roundo R-4-S angle bending roll, please call 515-999-2999 or email your request to sales@nsmachine.com. To request a quote for this Roundo R-4-S angle bending roll, use the “Request Quote” button on this page.