Pendant control

(1) set of tooling

Manufactured for Roundo to Model R-5-S specifications.

Machine comes with 1 year parts warranty

Diameter of standard rolls — 15.2”

Angles, leg out — 5" x 5" x 1/2" - 50" dia.

Angles, leg in — 4" x 4" x 1/2" - 50" dia.

Tees, leg out — WT 5 to 45" dia.

Tees, leg in — WT 5 to 60" dia.

Tees, on edge — WT 5 to 40" dia.

Flats, on edge — 6" x 5/8" to 45" dia.

Flats, on flat — 8" x 2" to 40" dia.

Squares — 2-3/4" to 32" dia.

Rounds — 3-1/2" to 40" dia.

Round pipe — 5 Sch 40 to 70" dia.

Square tube — 4” x 1/4”

Channels, leg out — C8 x 22.8 to 30" dia.

Channels, leg in — C8 x 22.8 to 35" dia.

Channels, on edge — C5 x 9 to 300" dia.

Diameter of front shaft — 5.5”

Diameter of rear shafts - 4.75”

Motor — 17.5 HP

Approximate weight — 10,200 lbs.

This angle roll was produced for Roundo and manufactured to R-5-S specifications. Roundo did not take delivery of this machine due to the termination of Roundo operations. It is in new condition and has not been put into service. The Roundo R-5-S has a capacity of 5” x 5” x 1/2” angle and comes equipped with a pendant control and one set of tooling.

For questions or to schedule an inspection of this Roundo R-5-S angle bending roll, please call 515-999-2999 or email your request to sales@nsmachine.com. To request a quote for this Roundo R-5- angle bending roll, use the “Request Quote” button on this page.